2.1.3
2020-11-08
Minor bugs fixed. Solved a readability problem when in Light Appearance
2.1.0
2020-05-06
It is now possible, in the section wet drawing slipping machines, enter your own drawing diagram and to check elongations, reductions and slip per pass relative to the machine characteristics. It is possible then to compare your diagram with the drawing set calculated by the program.
Is it also possible to use the program in your Mac (requires macOS 10.15)
The App is working also in dark mode.
2.0.1
2020-04-05
Updated to eliminate possible crash when inserting the slipping value
1.3
2020-02-04
Fixed a too sharp rounding problem on small diameters with Imperial units.
1.2
2018-03-13
Fixed some bugs: it was impossible to enter Carbon = 0,1%, increased inlet diameter to 40 mm, other minor bugs